Owalo 7000 pendant lamp is available in natural birch
Owalo 7000 pendant lamp is available in white laminated
Owalo 7000 pendant lamp is available in black laminated
Owalo 7000 pendant lamp is available in walnut veneer

Owalo 7000 pendant lamp:
Tranquil balance

A horizontal pendant that lights up both meeting rooms and dining areas. Comes with the latest in LED technology. Designed by architect Seppo Koho, launched in 2012. 

Colour:

Get it here!

Secto Design Owalo 7000 - Tranquil balance

Secto Design Owalo 7000 pendant lamp

Owalo 7000. Hotel Valo & Work. Helsinki, Finland. Photo by Uzi Varon

Owalo 7000. Design Dock, Helsinki Design Week. Photo by Uzi Varon

Owalo 7000. Locker & Légere Hotelbetriebs, St. Ruprecht / Raab, Austria. Photo by Markus Kaiser

Owalo 7000. Actavis Baltics Office, Vilnius, Lithuania. Design by Arch. Ruta Bagdzeviciute. Photo by Dualhead

More images of the Owalo 7000 pendant lamp here

Secto Design Owalo 7000 pendant lamp is available in four colours: birch, walnut, black and white.
Secto Design Owalo 7000 pendant lamp is 13 cm high, 9 cm wide, and 97 cm long.

Owalo 7000 pendant lamp

Handmade from PEFC-certified form-pressed birch in Finland by highly skilled craftspeople. Uses the latest LED-technology.

Finishing options

Shade Case CableCeiling cup
Natural birch White WhiteWhite
White laminated White WhiteWhite
Black laminated Black Black Black
Walnut veneer White White White

Product details

Material Form-pressed birch slats, fine textured powder coated steel case, acrylic diffuser
Dimensions Height 13 cm
Length 97 cm
Width 9 cm
Weight 3,1 kg
Package 119 × 22 × 18 cm, 5,1 kg
Voltage 100-240 VAC 50/60 Hz
Light source A built-in LED, 22 W, 3000 K, 2800 lm, CRI >80. This product contains a light source of energy efficiency class D.
Dimming Details
Cable 200 cm, textile cable, connector (+ a separate ceiling plug in Finland and Sweden), ceiling cup, 2 steel wires
Classification Ingress Protection IP20, IEC Protection Class II, CE marking
Installation Separate instructions on the website.
Maintenance Wipe dust regularly. To remove fresh stains wipe with a slightly damp cloth.

 

NOTE: Built-in step dimming. The lamp can be dimmed (to 70 %, 30 % and 15 %) by clicking the wall switch.

WARNING: The cable or light source can only be replaced by the manufacturer or an authorized service agent.

Assemble the cable holder

Step 1Be sure to insert the wire into the holder at least far enough to be able to clearly see it protrude from the other end of the holder. When attaching the holder into concrete or stone, use a screw anchor.
Step 2Push the wire sleeve to free the wire lock.
Step 3Cut off the extra wire.
Step 4Wire exit angle may not exceed 10°.

Connect and adjust the balance

Step 5Hold the lampshade. Push the wire sleeve to lower it down. Push the wire sleeve to free the wire lock.
Step 6Hold the lampshade. Pull the wire to raise it up.
Step 7Cut off the extra wire.
Step 8Cable straightener: Adjust position and tighten the screw.

Dezall lamptops

This Secto Design pendant uses the patented ceiling suspension by Dezall. Easy and quick to install, enables the ceiling cup to sit perfectly tight against the ceiling.

Step 1Lock the cord in the upper part of the screw, start in the middle. Then insert it into the opening along the thread. Push it down into the bottom of the channel.
Step 2Insert the screw, plug and remaining cord through the cover from below. Also insert it through the ring if this is to be used.
Step 3Put the two matching bottom parts together, facing each other, around the cord between the cover and the lamp. Insert the assembled bottom part into the cover by fitting the “wings” into the slots inside the cover. Push it into the cover until fully seated.
Step 4Hang the screw on the ceiling hook and connect the plug.
Step 5Move the lamptop upwards towards the screw hanging on the hook. When the screw and the bottom parts’ “nut” have come in contact inside the cover, start screwing the cover clockwise until it reaches the ceiling.
Step 6The lamptop is now sitting straight to the ceiling.

Round ceiling cup 

Height8,1 cm / 8,9 cm (with ring)
Outer upperØ 11,7 cm / 12,0 cm (with ring) 
Inner upperØ 11,2 cm / 11,7 cm (with ring)
Weight58 g / 74 g (with ring)
ColourWhite or black matt soft lacquer depending on the colour of the pendant
InformationThe round ceiling cup includes an additional ring, which enables leading the cable along the ceiling into the ceiling cup. The additional ring can also be used to cover a larger ceiling socket.

Any extra length of the cable can be swirled into the ceiling cup when altering the hanging height of the pendant.

Light distribution

Light distribution curve of Owalo 7000. Light distribution is shown in two perpendicular vertical planes (C-planes).

Download LDT

The energy label shows the energy efficiency class of this lamp model.

Mix and match lamps as you like!

See how our lamps look together in different arrangements and create your own eye-catching installation tailored to your interior.

Mix and match lamps

All lamps

Owalo 7000 pendant lamp ›

Loading form